These ARP main studs are made from 8740 chromoly steel and have a 190,000 psi tensile-strength rating. They are precision centerless-ground and thread-rolled to Mil-S-8879 specs, with a black oxide finish for corrosion resistance. The kits come complete with hardened washers and high-strength hex nuts.
Applications:
2006-2015 NC MX-5 2.0L
2006-2015 NC MX-5 2.3L (SWAP)
ARP Torque Specs
- Final torque: 60 ft-lbs
- Lubricant: ARP Ultra-Torque on the threads and under the nuts/washers
- Sequence: tighten in 3 equal steps following the factory Mazda torque sequence
All torque values assume ARP Ultra-Torque fastener assembly lubricant (included in the kit). Do not substitute motor oil — ARP notes it produces higher friction and inconsistent clamp load.
FAQ
Do I have to use ARP Ultra-Torque?
Yes. Every torque value above was developed by ARP using ARP Ultra-Torque lubricant, which is included in the kit. Using motor oil or moly paste instead will change the friction and give you a different (and inconsistent) clamp load at the same torque reading.
Can ARP studs be reused?
Yes. ARP studs can be reused as long as the threads are undamaged and they were not over-torqued. Clean and inspect the threads, re-lubricate with fresh ARP Ultra-Torque, and torque to spec.
Why three torque steps?
ARP specifies tightening in three equal steps following the factory torque sequence. Stepping up gradually seats the fastener evenly and gives a far more consistent clamp load than going straight to full torque.
Do I need to align-hone with main studs?
ARP recommends align-honing the main bores when installing aftermarket main studs, since the stronger fasteners distort the main caps differently than the factory bolts.
