null

ARP Head Stud Kit - NC Miata (2.5L)

(No reviews yet) Write a Review
UPC:
218-4702
$278.42 $156.13
(You save $122.29)

There are many important reasons to use ARP head stud kits for your 2.0 or 2.5 Mazda Miata, including the elimination of lifting your head, as well as protecting the threads in your engine block. Every ARP head stud kit exceeds the most stringent aerospace specifications. All kits come complete with hardened parallel-ground washers and aerospace quality nuts.  The studs are manufactured from 8740 chrome moly steel, heat-treated in-house to 190,000 psi tensile strength, and precision J-form threads rolled after heat-treat to create a fastener that has threads 1000% stronger than others.

Applications:

2006-2015 NC MX-5 2.5L (SWAP)

ARP Torque Specs

  • Final torque: 60 ft-lbs, reached in 3 steps (20 / 40 / 60 ft-lbs)
  • Lubricant: ARP Ultra-Torque on the threads and under the nuts/washers
  • Sequence: follow the factory Mazda torque sequence

All torque values assume ARP Ultra-Torque fastener assembly lubricant (included in the kit). Do not substitute motor oil — ARP notes it produces higher friction and inconsistent clamp load.

FAQ

Do I have to use ARP Ultra-Torque?
Yes. Every torque value above was developed by ARP using ARP Ultra-Torque lubricant, which is included in the kit. Using motor oil or moly paste instead will change the friction and give you a different (and inconsistent) clamp load at the same torque reading.

Can ARP studs be reused?
Yes. ARP studs can be reused as long as the threads are undamaged and they were not over-torqued. Clean and inspect the threads, re-lubricate with fresh ARP Ultra-Torque, and torque to spec.

Why three torque steps?
ARP specifies tightening in three equal steps following the factory torque sequence. Stepping up gradually seats the fastener evenly and gives a far more consistent clamp load than going straight to full torque.